Synology DS1813+ Przewodnik Instalacji Pobierz pdf (Strona 10)

10 Chapter 2: Hardware Setup

Add a RAM Module on DiskStation

The optional Synology RAM module 2GB (DDR3) is designed for DiskStation memory expansion. Follow the

steps below to install, check, or remove a RAM module on your DiskStation.

To install the RAM module:

1 Shut down your DiskStation. Disconnect all cables connected to your DiskStation to prevent any possible

damages.

2 Remove the 6 screws that secure the top case. Lift off the case and place it to the side.

Important: When you remove the case, you expose sensitive internal components. Avoid touching anything other

than the memory assembly when you remove or add memory.

3 Insert the new memory module in the slot:

a Align the notch on the gold edge of the module with the notch in the lower memory slot.

b Tilt the card and push the memory into the slot. Make sure the module is pushed in all the way.

c Use two fingers with firm, even pressure to push down on the memory module. You should hear a click

when the memory is inserted correctly.

Important: Hold the memory module by its edges, and do not touch the gold connectors.

4 Replace the top case. Replace and tighten the 6 screws you removed in step 2.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 22 23

Brak uwag

Synology DS1813+ Przewodnik Instalacji Strona 10